Solid wood king size bed frame – A bed crown is a canopy that is attached to the wall and hidden behind a piece of wood. Despite its name, the crowns of the bed are not always crown-shaped. Instead, cover a bed the shape of crown caps off a head. You could buy a crown bed from a home store, but it would be expensive. Making your own oversized king bed will cost less and require little effort. Cut three pieces of pine wood 1 by 4 inches to build the shape of the crown of the bed. The front piece should be 70 inches long. Make each side piece 7 inches long. Sand the wood with medium-grain sandpaper. Paint the wood with flat, latex paint a color that complements the decoration of the room. Apply two coats for complete coverage. Allow the paint to dry four to six hours between layer and layer.
Solid wood king size bed frame, place the front part of the crown along the work surface. Rest on one of its 1-inch long sides. Apply the wood glue to each 1-by-4-inch end of the front piece. Press a single 7-inch long side piece into the wood glue on one end of the front piece. Press the other 7-inch long side piece into the wood glue in front of the other end piece to create a three-sided rectangle. Make the edges flush between the front piece and the two side pieces. Nail a nail in each corner where a side piece contiguous to the front piece. Place a metal L-bracket on each corner where the front and side pieces meet. Fix the brackets by placing a screw through each hole in the bracket.
12 Photos Gallery of: Solid Wood King Size Bed Frame Design
Solid wood king size bed frame, return the rectangle three sides down on the work surface so the side pieces are point up. Place a piece of cloth that matches the decoration of your room along the back of the three-sided rectangle. From the side piece on the right side, pick and fix the fabric to the wood using a staple gun. Position the fabric until it reaches the center of the front piece. Repeat the process with another piece of cloth on the left side of the three-sided rectangle. Place an image ring that hangs from the 1-inch-wide exposed edge of each side piece. Place each ring 1 inch down from the top edge.